DIY keychain

For about two years now, 2 processors in a socket have been hanging on my backpack. There was an opportunity to make another such a keychain. Just a photo. For manufacturing on the basis of 478 sockets, a 1 mm drill is required, as the key on the processor is not symmetrical. On socket 7, everything is simpler. Well, a 2mm drill for attaching the ring.

A few more photos of the manufacturing process on my blog. You can find the link in my info, if interested.


2 processors are inserted into the socket from different sides:

Photo with the old man:

Just on the latch the processors are holding poorly, one, the one that is from below, will need to be glued. The upper one can be removed at any time by opening the socket.