Get rid of the noise of the system unit

Probably, more than half of people reading this topic to one degree or another suffer from the hum of the system unit. Sometimes, I want to throw him away. In fact, the first thought is the most correct - it really should be thrown away, but outside the wall. In my case, it was a kitchen and a balcony.

Lyrical offensive

To break through the wall of the house and rearrange the system unit - at first this thought strained me like electricity. Then I realized that this is no more complicated than doing any other work with your hands, changing the cooler, hard drives, etc. You just get used to the fact that the system unit should be under the table and therefore, even when reading, there is some discomfort. If desired, anything is possible.

Questions that you ask yourself before you begin

And what will be the effect?
We turn off the system unit, carry it to the room where we plan to install it, connect it. At startup, it’s a harsh application that loads the system. We come back and listen to the silence. Like? If not, then no further reading.

Is there enough wire length?
If you put the system unit directly behind the wall, in line with the monitor and the table at which you are sitting, then the standard length of the wires is enough. Personally, I didn’t increase or buy anything in my two cases.

Are there wires in the wall?
Of course there is, right in the place where you will make the hole;) We take the wiring detector and make sure that yes, the wire is there. Now we are moving a dozen centimeters to the side.

Hey, both power cables and USB and sound will go through one hole. Will there be no phoning?
Damn, you're right. you have to make your own tunnel under each cable. Do not forget to inform your home about this before starting work. It is very simple to check - you push the system unit back and collect all the wires that you plan to run through the reader into one bundle. If the acoustics start to fade, you will have to go broke on a shielded cable. Important : this must be checked before I drilled the first hole.

Is there enough of such a drill?
The most interesting question. The thickness of the walls seems to be described in SNiP , but it takes longer to look for it. Usually from 8 (drywall and other beauty) to 20 (old brick house) centimeters.
Life example: to take the system unit to the glazed balcony of the classic twelve-story building, I needed a drill of 30 centimeters and 2 hours of work.
Very often, insidious builders leave any garbage in the form of iron rods in the walls. They call it fittings, so the hole is made of perfectly round, because you really want this to yourself? Turns into a hole from a shot from an enemy cannon.

The drill is thin, and the hole should be large. How to drill?
On the wall, draw a circle and start drilling holes around the circumference, next to each other. When you go through the whole circle, then start drilling at an angle to connect the holes. Just don't break the drill. Then you can work with a chisel and a hammer.
When the hole is ready, first of all, drag the cable for power, then make sure that the last wire from the monitor no longer comes through and widen the hole a little.

Have a good fight against noise. Who dare to try - please take a photo in the skinny skin.
Pleased with the reaction of the guests: the unusual silence in the room, the monitor is on. They look under the table, and there is nothing there.